Introduction Congratulations on the purchase of this modern and high-qualityproduct. This instruction manual contains important information on safety, usage and disposal. Before using the product, familiarize yourself with all handling and safety guidelines. This devicee may only be used as described and for the purposes indicated. Please also pass these operating instructions on to any future owner(s).
SAVE THESE INSTRUCTONS OPERATING INSTRUCTIONS If the SUPPLY CORD is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. A short power-supply cord is to be provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord.
Returning the packaging to the materials cycle conserves raw materials and reduces the amount of waste that is generated. Dispose of packaging materials that are no longer needed in accordance with applicable local regulations. NOTE: If possible, keep the original packaging during the warranty period so that the device can be properly packed for returning in the event of a warranty claim.
Page 5
not be inserted further than the rear sealing ring and must lie between the front and rear sealing ring. If the bag lies over one or both of the sealing rings, the bag cannot be properly sealed. The bag opening must lie flat on the welding wire. Otherwise, welding will not work properly.
Page 6
Operating the equipment 1. How to Make a Bag from a Bonsenkitchen Vacuum Seal Roll: (Pic.1) (Pic.2) Open the cutter rest by pushing the Push down the cutter handle until handle and Pull enough length for hear a big lock-up sound. Make sure your content bag over the cutter rest.
Page 7
Push down both sides of the lid until a bag (as described in the “How to Make hear a big lock-up sound. (Pic.2) a Bag from a Bonsenkitchen Vacuum Seal Roll” section, on page 6), Place item(s) in bag, allowing at least 5cm (2 inches) of space between bag contents and the open end of bag.
Page 8
3. How to use “Soft” vacuum mode: (Pic.1) (Pic.2) Push down both sides of the lid until Press “Soft” button, indicator light turns hear a big lock-up sound.(Pic.1) on. (Pic.2) ① ② ③ ④ (Pic.3) (Pic.4) Open the lids by pressing the buttons Take out the bag.
Page 9
4. How to seal only: (Pic.1) (Pic.2) Push down both sides of the lid until If you want to seal a bag without vacuuming, hear a big lock-up sound. press “Seal” button, indicator light turns on. (Pic.2) ① ② ③ (Pic.3) Open the lids by pressing the buttons on both sides after indicator light turns off, then take out the bag.
NOTE: Once you have sealed 10 bags continuously, allow the appliance to cool down for about 15 minute. During this cool-down phase, you cannot start the appliance. After the cool-down phase, you can use the appliance as normal. Cleaning Unplug the unit before cleaning it. Make sure that no moisture can penetrate into the device.
When the plug does not fit fully in the outlet, reverse the plug. When it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Technical Data Model No.: VS3905 Operating Voltage: 120VAC 60Hz Power Consumption: 130W Max. Width for Shrink-wrapping: 300mm (11.81 Inch) Vacuum Value: <-50Kpa...
Need help?
Do you have a question about the VS3905 and is the answer not in the manual?
Questions and answers