Advertisement
3.1 Introduction
3.2 Hardware
requirements
Document SB10EN-30406-1.00 - © NARDA 2013
3 –PMM SET ADDRESS
This chapter is a guide for using the PMM SET Address Utility provided with
the PMM SB-10 Switching Control Box.
The PMM SET ADDRESS is an utility that integrates the PMM SB10
Switching Control Box and the PMM OR03 Optical Repeater.
When several PMM OR03 Optical Repeater with probe are connected to
the PMM SB-10 each of them need to be set with a different address.
With the PMM SET ADDRESS Utility you can associate an address at each
Optical Repeater connected to the PMM SB-10.
When several PMM EP600/EP601/EP602/EP603 are connected to the
PMM SB-10 and each of them need to be set with a different address,
it is suggested to use the utility SetAddEP600 provided with the probe
self. Please refer to EP600/EP601/EP602/EP603 user's manual for
detailed information regarding the utility.
Minimum requirements:
• Processor: Pentium
•
16 Mb of RAM;
•
10 Mb of free hard disk space;
•
1 free USB or RS232 port
•
Windows 95/98/2000/XP Operating System.
To guarantee the operation with PMM SET ADDRESS the firmware of
the OR03 must be updated to Version 2.08 or later.
The updates for PMM OR03 software and firmware are available for
download from the internet web site www.narda-sts.it or directly from
the commercial offices of NARDA.
PMM SET ADDRESS Instructions for use
Operating instructions
3-1
Advertisement
