Spirit Halloween Limb Ripper Easy-To-Follow Instructions

Please read all instructions carefully before assembling.
Care & Storage Instructions: Gently wipe clean with a soft cloth or feather duster only. Store product in its original package. Keep away from heat & moisture. For indoor use only. Save instruction sheet for future reference.
This item, when assembled by the following instructions, should take 5-10 minutes to assemble. Please follow the step by step guide
and enjoy your Limb Ripper.
PARTS LIST:
A
B
Base
I
H
Shirt
ASSEMBLY INSTRUCTIONS: Unplug when not in use. It is not a toy and is not intended for Children. Please use it with adult supervision.
C
B
A
Step 1:
NOTE: The longer end of the (A) Base goes
towards the front. First, assemble the (B) Legs to
the (A) Base as shown, and secure by aligning
the quick-connect push buttons into the pre-
drilled holes. Next, assemble the (C) Support
Poles into the tops of the (B) Legs as shown and
secure by aligning the quick-connect push
buttons into the pre-drilled holes.
Easy to Follow Instructions
C
Legs Support Poles
J
Head Left Arm
D
Step 2:
Next, lower (D) Pants over the (C) Support Poles
through the leg openings & out through the top
of the Pants. The bottoms of the leg openings
should cover the tops of the (B) Legs. Then,
assemble the (E) Torso Frame onto the (C)
Support Poles as shown, and secure by align-
ing the quick-connect push buttons into the
pre-drilled holes. Now pull up the (D) Pants
over the hip hoop found above the "waist" of
the (E) Torso Frame as shown.
01145531 Limb Ripper
D E
Pants
K L
Left Hand
E
F
Torso Frame Shoulder Support
M
Right Arm Right Hand
F
Step 3:
Attach the (F) Shoulder Support to the top of the
(E) Torso Frame as shown. Now, plug the UL
Power Adapter into the input receiving jack
marked "6V 1000-mA" on the Function Control
box and route the power cord through the left
pant leg and out behind the left (B) Leg.
Optional: If you choose to use (G) Step Here
Try-Me Activation Pad, plug the connecter into
the input receiving jack marked "TRY ME" on
the Function Control Box and set the Step Here
pad in front of the character when ready to
display.
G
Step Here Pad
A/C Adapter Specification:
Input: 100V~240VAC 50/60Hz
0.4A Max
Output: 6V DC 1A
Only use adapter with same
technical specification.
ON OFF / TRY ME
SENSOR
ADAPTER
VOLUME
INPUT: 6V
MOTION
1000mA
TRY ME
SENSOR
A/C
STEP ADAPTER
HERE
G