Advertisement
Installation Procedures:
Installation Steps:
1 Make sure the motorcycle is off and cooled down before
beginning installation of the PIM II.
2 Remove the seat, left and right side covers, air box and
fuel tank. (Refer to the factory service manual.)
3 Locate the stock fuel injector (Fig. 1), disconnect the
stock connector and connect the Yoshimura PIM harness
to the stock fuel injector and connector.
4 Route PIM harness along the left side of the frame, inside
of the upper engine mount tab.
5 Locate the crank position connector from the front of the
left side radiator (Fig. 2). Disconnect the connector and
connect to the PIM harness connectors (Fig. 3).
6 Locate power source connector on left side of the frame
(Fig. 4). Disconnect the power source connector and
connect to the PIM harness connectors.
Injector
connector
Fig. 1
Crank Position
Connector
PIM2 Crank Position
Connector
Power Source
Connector
Page 2
Fig. 2
Fig. 3
Fig. 4
Advertisement
