Download Print this page

General Installation Practices - banks Monster Ownersmanual

Sport exhaust system
Hide thumbs Also See for Banks Monster:

Advertisement

General Installation Practices

Dear Customer,
If you have any questions
concerning the installation of
your Banks Monster Exhaust
System, please call our Technical
Service Hotline at (888) 839-2700
between 7:00 am and 5:00 pm
(PT). If you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at (888) 839-
5600.
Thank you
1.
For ease of installation of your
Banks system, familiarize yourself with
the procedure by reading the entire
manual before starting work.
2.
The exploded view (pages 4-5)
provides only general guidance. Refer
to each step and section diagram in
this manual for proper instruction.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver's side, and the right side to the
passenger's side.
4.
Disconnect the ground cable from
the battery (or batteries, if there are
two) before beginning work.
5.
Route and tie wires and hoses a
minimum of 6" away from exhaust
heat, moving parts and sharp
edges. clearance of 8" or more is
recommended where possible.
2
96572 v.2.0
6.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer's safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides; put the transmission in
park; set the hand brake; and place
blocks behind the rear wheels.
Caution! Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry
or any other item not intended
specifically for this use.
7.
During installation, keep the work
area clean. Do not allow anything
to be dropped into intake, exhaust,
or lubrication system components
while performing the installation, as
foreign objects will cause immediate
turbocharger and/or engine damage
upon start-up.
Note: Prior to beginning any work,
please verify the build date of your
vehicle.
Certain steps in this manual are
model-year specific, so be sure to read
each step carefully before performing
any work.

Advertisement

loading