Download Print this page

banks Monster Owner's Manual

Exhaust system 2008 ford 6.8l (v-10) & 2011 ford 6.2l (v-8) crew cab short (6.75ft) bed f-250/f-350 super duty
Hide thumbs Also See for Monster:

Advertisement

Quick Links

Owner' s Manual
with Installation Instructions
Banks Monster
®

Exhaust System

2008 Ford 6.8L (V-10) &
2011 Ford 6.2L (V-8) Crew Cab Short (6.75ft) Bed
F-250/F-350 Super Duty
THIS MANUAL IS FOR USE WITH MONSTER ExHAUST SYSTEMS 48725

Advertisement

loading

Summary of Contents for banks Monster

  • Page 1: Exhaust System

    Owner’ s Manual with Installation Instructions Banks Monster ® Exhaust System 2008 Ford 6.8L (V-10) & 2011 Ford 6.2L (V-8) Crew Cab Short (6.75ft) Bed F-250/F-350 Super Duty THIS MANUAL IS FOR USE WITH MONSTER ExHAUST SYSTEMS 48725...
  • Page 2: Tools Required

    stands, ramps or a commercial hoist. General Installation Follow the manufacturer’s safety Practices precautions. Take care to balance the vehicle to prevent it from slipping or Before starting work, familiarize falling. When using ramps, be sure the yourself with the installation procedure front wheels are centered squarely by reading all of the instructions.
  • Page 3 96524 v.3.0...
  • Page 4 Monster Exhaust System Installation muffler. Remove the factory muffler Disconnect the negative (ground) and tailpipe assembly by removing the cable from the battery (if there is more factory band clamp on the muffler to than one battery, disconnect both intermediate pipe connection.
  • Page 5 Insert the hanger clamp pin into the rubber grommet. Install the inlet of the Install the supplied 3” hanger Banks Monster Muffler (note the muffler clamp onto the inlet of the Banks inlet labeling) onto the intermediate intermediate pipe. Install the Banks...
  • Page 6 Figure 4 96524 v.3.0...
  • Page 7 All rubber hanger should be facing the tailpipe hanger pin into the forward (see Figure 7). corresponding vehicle rubber hanger. Install the tailpipe into the Banks Remove the protective covering Muffler outlet. Lightly tighten the rear from the tailpipe tip.
  • Page 8 Figure 6 Placement of template on Passenger side rear undercarriage lining. Figure 7 BANKS POWER PERFORMANCE EXHAUST EXHAUST SYSTEMS...