Canmax CM-2D600 Quick Start

1. Configuration Flowchart
Please make sure you always start a scan sequence with ENTER
barcode and end with END barcode as a successful attempt.
ENTER barcode
desired
*/$%ENTR*
barcodes
2. Product Overview
○ Press Scan Button to read barcodes.
1
○
Press Small Tirgger to perform supplementary fucntions.
2
○ Good Read Indicator indicates whether the barcode is
3
decoded. Green LED shows a successful decodeing attempt.
○ Mode Indicator indicates the current operation mode status.
4
Blue LED stands for Bluetooth mode, green LED for Cable mode,
and orange LED for Memory mode
○ Power Indicator indicates the battery charge status.
5
when the battery is running low, red LED light will be on
to show a poor charge level. Once the charging
process is completed, red LED will flash slowly to show
a full battery charge.
○ Strape Hole
6
○
Secure the interface cable into USB Port to charge the
7
battery or transmit data.
○ Replace the battery in the battery compartment.
8
3. Einstellen
3-1. Operation Mode
We offer a selection of mode combinations, including 3 in1
functions, for your convenience to improve efficiency at work.
Before reading the below barcodes, please scan Enter label first to
END barcode
ensure a successful configuration.
*ZEND*
Cable
*A40C0*
Bluetooth
*A40C3*
Cable+BT
*A40C4*
3-2. Output Interface in Cable mode
After scanning Enter barcode, specify which output interface
the device works with in Cable mode.
USB HID
*B21D1*
4. Basic Scanner Operations
You can perform most of below basic operations by either
scanning the barcode sequences or using the button triggers.
4-1. Mode Switch
Button Trigger
Keep holding Scan Button till the LED light turns from a rapidly
1
des Scanners
Memory
*A40C1*
Cable+Mem
*A40C2*
Mem+BT
*A40C5*
Cable+Mem+BT
*A40C6*
USB COM
*B21D2*
RS232
*B21D3*
blinking color into a solid color. After a release of Scan Button,
you, by observing the LED light colors, can learn which
operation mode your scanner is switched to.
Scan Sequence
After reading ENTER label, scan the below appropriate
barcode to switch to the desired operation mode.
To Cable Mode
*ZTOS*
To BT Mode
*ZTOB*
4-2. Transmit all barcode data
Button Trigger
Step 1 Secure the interface cable to both the barcode reader
and the Host PC Open the preferred word processing
software to receive the scanned data.
Step 2 After holding Small Trigger long enough to trigger off a
solid LED light, release Small Trigger.
Step 3 While the orange LED starts flashing rapidly, press Scan
Button once again to transmit all barcode data.
Scan Sequence
Scan Data Memory Tx barcode after reading Enter label.
Data Memory Tx
*ZMTX*
4-3. Clear all saved barcode data
Button Trigger
Step 1 Configure the scanner to be in Memory mode.
Step 2 While holding Small Trigger till orange LED starts
2
To Mem Mode
*ZTOM*
3