Function Introduction 3; Copy; Compare; Copy & Compare - Century KD25/35MS2 User Manual

FUNCTION INTRODUCTION 3

1. Copy

It copies data from source HDD to target HDD. Please make sure you have
choose correct copy mode you like to use, about the three copy modes
please refer to function [6.1 Copy Area] for details.
The default setting is "System and Files".

2. Compare

It is used to check if the data on source HDD is identical to target HDD
after duplication.
3. Copy & Compare
It makes copy first and then compare copied HDD with source HDD to
ensure data correctness.
Before copy, please pay attention to the following setting
Select the suitable copy mode by function 6.1 Copy Area, the Default
setting is quick copy mode "System and Files".
The special features of quick copy System and Files:
• Using this copy mode, the system will analyze the source's copy data area
only, and only copy data and system file of the HDD.
There is no need to copy rest of empty space.
• This function only support FAT, NTFS and Linux (Ext2and Ext3 Ext4, GPT
and Dynamic HDD.)
• It is strongly suggested to use the same capacity of source and target HDD.

4. Erase

Please choose the appropriate erase method when you like to dispose or
re-use the HDDs.
Function 6.3 Erase Master is to determine erase source HDD or not.
The default setting is "Disable erase source HDD".
The function can be stopped while processing by pressing [ESC] for about 3~4
seconds.
7
先頭ページへ
28
〈KD25/35MS2〉
JA
EN
CT