VTech 6041 User Manual page 43

Troubleshooting
Problem
My cordless handset
beeps and s not
performng normally.
Common cure for
electronc equpment
40
Suggeston
• Make sure the power cord s securely plugged nto the telephone base. Plug the unt nto a
dfferent workng electrcal outlet not controlled by a wall swtch.
• Move the cordless handset closer to the telephone base. It may be out of range.
• Reset the telephone base by unpluggng the unt's electrcal power. Wat for 15 seconds and
plug t back n agan. Allow up to one mnute for the cordless handset and the telephone base
to synchronze.
• Other electronc products can cause nterference to your cordless telephone. Try nstallng
your telephone as far away from these electronc devces as possble: wreless routers, rados,
rado towers, pager towers, cellular telephones, ntercoms, room montors, televsons, personal
computers, ktchen applances and other cordless telephones.
• If the unt s not respondng normally, try puttng the cordless handset n the telephone base
or the charger. If t does not seem to respond, try the followng (n the order lsted):
• Dsconnect the power to the telephone base.
• Dsconnect the battery on the cordless handset.
• Wat a few mnutes before connectng power to the telephone base.
• Re-nstall the battery and place the cordless handset nto the telephone base or charger.
• Wat for the cordless handset to synchronze ts connecton wth the telephone base. Allow up
to one mnute for ths to take place.
www.vtechphones.com