Installation Of Battery Pack In Handset - Gigaphone 2420 User Manual

Installation of Battery Pack in Handset

1
The original Handset that is shipped with your GIGAPHONE system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension numbers
in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.
Follow the steps below:
1.
Remove the battery cover by
pressing on the indent and sliding
downward.
2.
3
Place the new battery pack in the
handset with the metal contacts
aligned with the charge contacts in
the battery compartment.
3.
Replace the battery cover by sliding
it upwards.
4.
If the new battery pack is not already
charged, place the handset in the
base unit, or a remote charging
stand, and allow it to charge for 12
hours.
maintenance charge of 8 hours
should be sufficient.
2
8
After initial charge, a