NOTE: Your Handset that comes with the v 2651/2656 system is registered
to the Base at the factory. The following steps are for registration of
additional Handsets (model# v 2600):
Enter Base ID Code
.
1
After charging the Handset, remove it from its
Charge Cradle. If the screen will displays
SEARCHING FOR BASE, press NEW. If the
screen displays ENTER BASE ID, go to step 2.
.
2
Enter the 15 digit Base ID Code, located on the
underside of the Base Unit. The ID Code can
include numbers (0-9) and characters (*).
.
3
Press OK . The Handset will display: PLEASE
WAIT!!
.
4
Wait approximately 15 seconds. The Handset will
display:
FOUND BASE
NOTE: Occasionally, it will take longer than 15
second for the Handset to find the Base Unit.
This is normal.
If the Handset displays: BASE BUSY TRY LATER,
this indicates that the system is in use. Wait until
the Base Unit is in the idle (on hook) mode, and
repeat steps 2 to 4.
Congratulations! You can now enjoy the benefits of your
VTech multi-Handset system.
Registration
6
1.
Antenna
2.
Earpiece
3.
Scroll Keys
4.
Headset Jack (2.5mm)
5.
On (Flash)
6.
Dialing Keys (0-9, *, #)
7.
Handsfree Speakerphone
The Handset Layout
8. LCD Display
9.
Select/Menu
10. Off (Clear)
11. Intercom
12. Microphone
7