Getting Started; Installation Of Battery Pack In Handset - VTech 2600 User Manual

Getting Started

Registration And Operation Of The VTECH v 2600
Accessory Handset
Your v 2651 or v 2656 system can support up to 4 Handsets.
The accessory Handset v 2600 consists of the following:
Setup
Setup Of The v 2600
Accessory Handset
1.
Plug the AC power adapter into an
electrical outlet.
2.
Install the battery pack, as described
on the following page.
4

Installation of Battery Pack in Handset

The original Handset that is shipped with your v 2651 or v 2656 will be automatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2 , HANDSET 3 , HANDSET 4 .
Whenever a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.
BEFORE USING YOUR HANDSET(S), CAREFULLY PEEL OFF THE PROTECTIVE
FILM, COVERING THE DISPLAY.
Follow the steps below:
1.
Remove the battery cover by pressing
on the indent and sliding downward.
2.
Align the two holes in plug with the
socket pins. Insert the plug into
socket. Place the battery pack into
the compartment with the wires in
one of the lower corners, along the
bottom of the battery pack.
3.
Replace the battery cover by sliding
it upwards.
4.
If the new battery pack is not already
charged, place the handset in the
base unit, or a remote charging stand,
and allow it to charge for 12 hours.
After the first charge, a drained
Handset battery pack will recharge in
approximately 8 hours.
5