Advertisement
STEP 1
Refer to PLAN VIEW and FOOTING LAYOUT to locate swing frame.
STEP 2
Excavate footing as shown in FOOTING LAYOUT and FOOTING DETAIL. Place a 2" spacer block in
the bottom of each hole.
STEP 3
Select top rail(s) of swing frame (2-3/8"x132"), two end yokes and center yoke(s) if applicable. Insert top
rail(s) fully into longest leg of each swing yoke, then install and tighten set screws (see Detail A and B).
STEP 4
Select top rail assembly and swing legs. NOTE: The standard swing legs (2-3/8"x144") are used for
bi-pod swing frames and side legs of the 8' tri-pod frame. The 2-3/8"x168" swing legs are used for the 10'
tri-pod swing. The swing legs with bend are used for the ends of the tripod (2-3/8"x136" with bend for the
8' tri-pod and 2-3/8"x168" with bend for the 10' tri-pod). NOTE: Bent end inserts into swing yoke. With
top rail assembly laying on ground, insert swing legs fully into legs of swing yokes. Install and tighten set
screws (see Detail A).
Detail A
End Yoke for Bi-Pod
Detail B
Middle Yoke for
Bi-Pod and Tri-Pod
SWING FRAMES
DATE: 08/29/2014
BI-POD and TRI-POD SWING FRAME
Swing End Yoke (long leg)
Top Rail
1/2"x3/4" Set Screw
(two in each junction)
Swing Leg
(144" Long)
End Swing Leg with Bent End
(bent end inserts into swing end yoke leg)
136" for 8' tri-pod
168" for 10' tri-pod
Swing Middle Yoke (long leg)
1/2"x3/4" Set Screw
(two in each junction)
Page 7 of 20
INSTALLATION GUIDELINES
Top Bar
Swing End Yoke
(long leg)
Top Rail
Swing Leg
144" for 8' tri-pod
168" for 10' tri-pod
Detail A
End Yoke for Tri-Pod
1/2"x3/4" Set Screw
(two in each junction)
Swing Leg
144" for 8' tri-pod
168" for 10' tri-pod
Advertisement
