Insert The Batteries Into The Remote Control; Connect The Antenna To Your Tv; To Switch The Tv On - Hitachi 55HK5100 Nstruction Manual

1
Insert the batter es nto the Remote Control
Remove the back cover to reveal the battery compartment. Insert two
size AAA batteries. Make sure the (+) and (-) signs match (observe
correct polarity). Do not mix old and new batteries. Replace only with
same or equivalent type. Place the cover back on.
A message will be displayed on the screen when the batteries are low
and must be replaced. Note that when the batteries are low, the
performance of the remote control may be impaired.
Batteries should not be exposed to excessive heat such as sunshine,
fire or the like.
2

Connect the antenna to your TV

3
Connect the TV to the ma ns socket
4
To sw tch the TV on
Connect the power cord to the ma ns socket. Then the
standby LED l ghts up.
To sw tch on the TV from standby mode e ther;
1. Press the Standby button, a numer c button or
Programme +/- button on the remote control
2. Press the m ddle of the s de funct on sw tch on the TV n
Qu ck Start Gu de
REAR SIDE OF THE TV
Satell te
ANT SAT
ANT-TV
Aer al
or
Cable