Table of Contents
Advertisement
1. Remove the lower plastic body of the antenna [not the mounting base] and pass
the short cable with its connector through.
2. Seal the hole around the shaft passing through with a suitable weather sealer [not
supplied] before installing the lock washer and nut supplied.
• For substrates between ¼" to 1" thick - only the 9/16" dia. hole is required.
1. As above, remove the lower plastic body of the antenna.
2. The extension shaft is now required to be attached to the threaded metallic post of
the antenna, ensuring that the cable is first located in the slot of the threaded
metallic post.
3. This assembly can now be passed through the 9/16" hole and as above, seal before
installing the lock washer and nut.
Fig. 1
7
Advertisement
Table of Contents
