Panasonic KX-TC1466LAB Operating Instructions Manual page 8

6
Quick Guide
6-A Preparation
1 Connect as shown.
Fasten the
AC adaptor
cord to prevent
it from being
disconnected.
Hook
Raise the
antenna.
To Single-Line
Telephone Jack
Telephone Line
Cord
≥The AC adaptor must remain connected at all times.
6-B Operation
IN USE
Indicator
(OFF)
(–––/FLASH)
(AUTO/PROGRAM)
(CH)
≥When the IN USE indicator flashes or the unit beeps while it is in use,
charge the battery.
Making Calls
(–––/FLASH) . ¤ Dial a telephone number.
Press
(OFF)
≥To hang up, press or place the handset on the base unit.
≥If noise interferes with your conversation, press
channel or move closer to the base unit.
For maximum distance and
noise-free operation, place
the base unit in a HIGH and
CENTRAL location with no
obstructions or interference
from electrical appliances.
To Power Outlet
AC Adaptor
(HANDSET\LOCATOR)
(CH)
to select a clearer
2 Install the battery in the handset
and close the handset cover,
locking it into place.
3 Charge the battery for
about 15 hours.
≥The IN USE/CHARGE
indicator lights and a beep
sounds.
IN USE/CHARGE Indicator
To select the dialing mode TONE (preset) or PULSE
You can program the dialing mode using the handset near the base
unit. The IN USE indicator light must be off before programming.
¤ ¤
(AUTO/PROGRAM) ($)
Press
Answering Calls
Lift the handset off the base unit and press
(OFF)
except .
Speed Dialer
You can store up to 10 phone numbers in the handset. The dialing buttons
(0) (9)
( to ) function as memory stations. The IN USE indicator light must be
off before programming.
To store phone numbers in memory
¤ Station Number ((0) to (9))
(AUTO/PROGRAM)
Press
¤
Phone number (up to 16 digits)
To dial a stored number
¤
(–––/FLASH)
(AUTO/PROGRAM)
Press
Handset Locator
(HANDSET\LOCATOR)
Press on the base unit.
≥The handset beeps for 2 minutes.
(HANDSET\LOCATOR)
≥To stop paging, press
handset.
Section 6
Black
Red
Lead
Lead
OR
(#)
(PULSE)
¤
(AUTO/PROGRAM)
OR
($)
(TONE)
(–––/FLASH)
or any button
¤
¤
(AUTO/PROGRAM)
.
¤
Station Number ((0) to (9))
(OFF)
again or press on the
.
.