Panasonic KX-TC1466LAB Operating Instructions Manual page 6

5
Things You Should Know
5-C Wall Mounting
This unit can be mounted on a wall.
1 Push the lower side of
the hook (1) and pull
down the hook until it
locks (2), so the tab
holds the handset.
2
Remove the wall
mounting adaptor.
3 Connect the AC
adaptor.
Tuck the telephone
line cord inside the
wall mounting adaptor,
then push it in the
direction of the arrow
(1 and 2).
≥The word "UP WALL"
should face upward.
4 Install screws using
the wall template
below. Connect the
telephone line cord.
Mount the unit, then
slide down.
≥Raise the antenna.
Wall Template
8.3 cm
2
1 1
2
1
2
To Power
Outlet
1
Screws
8.3 cm
To Single-Line
Telephone Jack
5 To charge the battery:
Fit the handset hole in the tab
(1) and fix the charge
contacts (2).
≥Make sure to place the
handset with the keypad
facing down.
≥The IN USE/CHARGE
indicator lights and a
beep sounds.
5-D Battery Replacement
If the IN USE indicator flashes after a few telephone calls even if the
battery was fully charged, replace the battery with a new Panasonic
PQWBTC1461 (P-P504) battery.
1 Press the notch on the
handset cover firmly (1) and
slide it as indicated by the
arrow (2).
2 Remove the old battery.
Then install the new one.
≥Insert the battery plug into
the connector as shown in
the picture.
≥Be sure wires are free from being pressed by the battery body
or handset cover.
3 Close the cover. Make sure you charge the new battery
for about 15 hours.
5-E Adding Another Phone
This unit will not function during a power failure. To connect a standard
telephone on the same line, use a T-adaptor.
Standard Telephone
To Single-Line
Telephone Jack
T-Adaptor
"
Hole
Tab
1
2
1
2
Black
Red
Lead
Lead
Telephone
Line Cord
Things