Table of Contents
Advertisement
Assembly Tips:
Attention:
If you are using an electric screwdriver in the assembly, please set at low torque
and do not over tighten the hardware. When assembling individual parts, loosely tighten screws
until all screws are inserted, then tighten completely. Do not strip out screws.
Assembly Instructions
Find a clean, level place to begin the assembly of your Air Hockey table.
Leave Air Hockey Table Cabinet (P1) face down in the carton to assemble.
Remove all the parts from the box and verify that you have all of the listed parts as shown
on the parts identifier page. Carefully cut or tear the four corners of the box so that the
bottom of the box can be used as your work surface.
1 pc - P1 Air Hockey Cabinet
12 pcs - H1 8mm x 35mm Allen Head Bolt
STEP:1
Attach the Left Legs P2 and Right Legs P3 to the Air Hockey Cabinet P1 using Allen Head Bolts H1
and Flat Washers H2 as shown in FIGURE 1. Use Allen Wrench T1 to tighten Bolts.
H1
PARTS REQUIRED:
P2
H2
FIGURE 1
2 pcs - P2 Left Leg
12 pcs - H2 8.5mm x 22mm Flat Washer
P3
C1 Air Motor w/ ON/OFF
switch in the powercord
5
2 pcs - P3 Right Leg
P3
P2
Advertisement
Table of Contents
