Makita EB7660TH Original Instruction Manual page 10

Stopping the engine
For tube throttle model: Release the throttle trigger and then set the
stop control lever to "O" position.
2
1
Fig.22
► 1. Throttle trigger 2. Stop control lever
For hip throttle model: Set the throttle lever to the low speed posi-
tion to reduce the engine speed. Then set the stop switch to "O"
position.
Fig.23
► 1. Throttle lever 2. Stop switch
Prevention from carburetor icing
NOTICE:
When environmental temperature is higher than
10°C, always return the lever to normal (sun mark) setting.
Otherwise the engine may be damaged by overheating.
When the environmental temperature is low and humidity is high,
water vapor may freeze inside the carburetor and the engine drives
unsteadily (carburetor icing). Change the setting of the anti icing lever
as follows if necessary.
Environment temperature is higher than 10°C: Turn the lever to nor-
mal position (sun mark).
Environment temperature is equal or lower than 10°C: Turn the lever
to anti-icing position (snow mark).
Fig.24
1
2
10 ENGLISH
Adjusting shoulder strap
1. Adjust the shoulder strap to a length that is comfortable to work
while carrying the blower.
To fasten the strap, pull the end of the strap downwards.
1
Fig.25
► 1. Shoulder strap
To loosen the strap, pull up the end of the fastener.
Fig.26
► 1. Fastener
2. Pull the stabilizer strap until there are no space left between your
back and the blower housing.
To fasten the strap, pull the end of the strap downwards.
1
Fig.27
► 1. Stabilizer strap
To loosen the strap, pull up the end of the fastener.
1