Table of Contents
Advertisement
8
Install the Decals
Parts needed for this procedure:
2
Decal
1
Decal 110–8869, danger
1
Decal 110–8973, CE danger (Europe only)
Procedure
1. Install each decal at locations below as follows:
A. Thoroughly clean the area where you will install
the decal.
B. Dampen the area with water or mildly soapy water.
C. Peel the decal from the backing and install it in
place.
D. Squeegee across the surface of the decal, starting
at the center of the decal and working toward the
edges, using overlapping strokes.
2. Using the dimensions shown in Figure 13, locate and
affix a CROSSTRAX decal to the lower rear corner
of each side of the hood.
Figure 13
1. 4.00 inches
3. Affix the appropriate danger decal over the existing
decal on the operator platform (Figure 14):
•
For domestic units apply decal 110-8869.
•
For CE (European) units apply decal 110-89673.
2. 1.00 inch
1. Danger decal
10
Figure 14
Advertisement
Table of Contents
