Toro 1800 Power Curve Operator's Manual page 2

•
Never attempt to make any adjustments while the motor is running
(except when specifically recommended by manufacturer).
•
Always wear safety glasses or eye shields during operation or
while performing an adjustment or repair to protect eyes from
foreign objects that may be thrown from the machine.
Operation
•
Do not put hands or feet near or under rotating parts. Keep clear
of the discharge opening at all times.
•
Exercise extreme caution when operating on or crossing gravel
drives, walks, or roads. Stay alert for hidden hazards or traffic.
•
After striking a foreign object, stop the motor, remove the ignition
key, thoroughly inspect the snow thrower for any damage, and
repair the damage before restarting and operating the snow
thrower.
•
If the unit should start to vibrate abnormally, stop the motor and
check immediately for the cause. Vibration is generally a warning
of trouble.
•
Stop the motor whenever you leave the operating position, before
unclogging the rotor blade housing or discharge chute, and when
making any repairs, adjustments or inspections.
•
When cleaning, repairing, or inspecting the snow thrower, stop
the motor and make certain that the rotor blades and all moving
parts have stopped.
•
Exercise extreme caution when operating on slopes.
•
Never operate the snow thrower without proper guards and other
safety protective devices in place and working.
•
Never direct the discharge toward people or areas where property
damage can occur. Keep children and others away.
•
Do not overload the machine capacity by attempting to clear snow
at too fast a rate.
•
Look behind and use care when backing up with the snow thrower.
•
Disengage power to the rotor blades when snow thrower is
transported or not in use.
•
Never operate the snow thrower without good visibility or light.
Always be sure of your footing, and keep a firm hold on the
handles. Walk; never run.
Clearing a Clogged Discharge Chute
Hand contact with the rotating rotor blades inside the discharge chute
is the most common cause of injury associated with snow throwers.
Never use your hand to clean out the discharge chute.
To clear the chute:
•
Shut the motor off!
•
Wait 10 seconds to be sure the rotor blades have stopped rotating.
•
Always use a clean-out tool, not your hands.
Maintenance and Storage
•
Check all fasteners at frequent intervals for proper tightness to be
sure the equipment is in safe working condition.
•
Always refer to the Operator's Manual for important details if the
snow thrower is to be stored for an extended period.
•
Maintain or replace safety and instruction labels, as necessary.
•
Run the machine a few minutes after throwing snow to prevent
freeze-up of the rotor blades.
SAVE THESE INSTRUCTIONS
Safety and Instructional Decals
Safety decals and instructions are easily visible
to the operator and are located near any area
of potential danger. Replace any decal that is
damaged or lost.
1. To engage the auger,
squeeze the control bar.
Setup
Note: Determine the left and right sides of the machine from the
normal operating position.
Installing the Upper Handle and Chute
Crank
1. Stand the snowthrower on its wheels and position the upper
handle.
2. Inspect the open internal wiring; if it is damaged, do not assemble.
Contact an Authorized Service Dealer.
2
On Handle
114-8986
2. Release the control bar to
disengage the auger.
114-9286