Toro 09501 Operator's Manual page 17

operating level, add approximately 9 liters.
NOTE: Drain plugs are also at the bottom of each (3) gear case.
Check the Right-Angle Gear Case Oil
Level
After every 25 hours of operation, or seasonally, whichever
comes first, check the level in the right-angle gear case (Fig. 19)
1. With the machine on a levels surface, remove the oil fill
plug.
2. Add SAE EP 90W gear oil, if needed and install the fill
plug.
NOTE: Gear capacity is 750 ml.
Check the Pick-off Gear Case Oil
Level
After every25 hours of operation, or seasonally, whichever
comes first, check the level in the pick-off gear case.
1. With the machine on a levels surface, remove the gear case
cover (Fig 20).
2. The oil level should be to the center of the gear shafts
(Fig. 21). If the level is low, add SAE EP 90W gear oil and
install the cover.
NOTE: Should major failure of the pick-off gear case compo-
nents occur, the gear oil will be contaminated and should be
drained. Flush the gear case and add fresh oil. The gear case oil
drain plug is at the lower left rear side of the case (Fig. 22).
Gear case capacity is 5.5 liters.
Figure 18
1. Reservoir Drain Plug
Figure 19
1. Right-angle gear case
2. Gear case fill plug
2
1
Figure 20
1. Pick-off gear case
2. Gear case cover
17