Toro 09501 Operator's Manual page 16

Check the Reservoir Level
After every25 hours of operation, or seasonally, whichever
comes first, check the level of in the reservoir.
1. With the machine on a level surface, remove the oil fill plug
and dipstick assembly from the reservoir (Fig 17).
2. The oil level should be between the two marks on the dip-
stick. If the oil level is not between the dipstick marks, add
SAE EP 90W gear oil until the oil level is correct.
NOTE: Under normal conditions, the reservoir oil level should
not drop. If the oil level is low, check for signs of leakage and
correct , as necessary. Should a major failure of the gearbox
components occur, drain the gear oil, flush the reservoir and
install fresh oil. The reservoir oil drain plug is located at the
lower left side of the reservoir (Fig. 18). To refill the reservoir to
16
Figure 14
Figure 15
Figure 16
2
Figure 17
1. Fill plug and dipstick
2. Oil level between marks
3. Reservoir fill hole
1
3