Advertisement
12. Loosely install the pump hose assembly to the 45
degree fitting on pump and to the lower hole in
bulkhead bracket with a washer and a nut (Figure 7 &
Figure 8).
Note: The 45 degree fitting on pump may have to be
rotated slightly to align with hose assembly.
G010146
1
1. Pump
2. Pump hose assembly
13. Loosely install a hydraulic hose to the pump hose
assembly (lower bulkhead) and to upper wheel motor
fitting (Figure 7).
14. Loosely install a hydraulic hose to hydraulic hard line
(upper bulkhead) and to bottom wheel motor fitting.
Note: The hoses must not contact tire or rim.
15. Tighten fittings.
16. Turn steering fork fully side to side to check for proper
hose flex and position. With steering wheel in full right
turn, it may be necessary to rotate rear hydrostat hose
fitting slightly downward to gain clearance with rear
wheel motor.
Note: The hoses should not rub on tire, rim, tanks,
steering fork, or steering hoses. It may be necessary to
rotate fuel shut off fitting (under fuel tank) slightly to
avoid fuel filter touching three wheel drive hoses.
Note: The hydraulic lines must not be twisted, kinked,
have sharp bends, or touch sharp edges, moving parts,
or engine exhaust parts.
17. Tighten all fittings.
18. Fill and check hydraulic oil reservoir level.
19. Connect positive then negative battery cables to battery.
Note: Connect negative cable last.
20. Start engine and cycle the traction and lift cylinders
to purge the air.
2
3
Figure 8
3. 45 degree fitting
21. Check hydraulic oil level.
4
Advertisement
