Adjusting The Transport Rollers; Mounting The Verticutter Reel - Toro Reelmaster 7000-D Operator's Manual

2. Move the scraper rods in or out to attain 0.0 to 0.03
inch (0.0 to 0.75 mm) clearance between the scraper
and roller.
3. Ensure that the scraper rod is parallel to the roller
and to the level surface.
4. Tighten the flange nuts to lock the adjustment.
6
Adjusting the Transport
Rollers
No Parts Required
Procedure
Before the verticutters are lowered to the shop floor
or removed from the traction unit, lower the transport
rollers (Figure 6) to protect the blades from hard surface
contact.
1. Remove the cotter pin that secures the transport
roller bracket to the side plate pin.
2. Position the transport roller as follows:
• Lower the roller bracket before the verticutter is
lowered to the shop floor.
• Raise the roller bracket after the verticutter is
raised to the operating position.
3. Secure the transport roller bracket to the side plate
pin with the cotter pin.
4. Repeat the procedure on the opposite end of the
verticutter.
7

Mounting the Verticutter Reel

No Parts Required
Procedure
Important: When lowering the verticutter reels,
care must be taken to prevent damage to the reel
blades due to contact with a concrete floor or a
paved surface. Lower the transport rollers before
lowering the verticuttiers to a concrete floor or a
paved surface.
The verticutters can be installed at any of the five
locations on the traction unit. Figure 7 shows the
orientation of the hydraulic drive motor for each of the
locations. For any of the locations requiring the motor
to be mounted on the right end of the verticutter, install
a counterweight on the left end of the verticutter. For
the locations requiring the motor to be mounted on
the left end, install a counterweight on the right end of
the verticutter.
Note: Counterweights are shipped installed to the right
end of the verticutters. The bolts on the left end are to
be used for securing the hydraulic motor.
Verticutter reels are mounted to traction unit the same
way cutting units are. Refer to Traction Unit Operator's
Manual for mounting instructions.
7
Figure 7