Advertisement
2
Installing the Basket Guides
and Brackets
Parts needed for this procedure:
1
Basket guide
1
Basket bracket
1
Roll pin
1
Washer
1
Left-hand torsion-spring (gold)
1
Right-hand torsion-spring (black)
1
Basket collar
2
Flat washer (0.344 x 0.875)
1
Bolt (5/16 x 1–1/4 inch)
1
Bolt (5/16 x 1/2 inch)
1
Plastic washer
Procedure
1. Remove the cutting units from the cartons. Assemble
and adjust them according to the Operator's Manual for
the cutting unit.
2. Use
Figure 2
to determine the locations where the
basket guides or basket brackets must be mounted to
the cutting-unit carrier-frames.
1. Center basket
2. Left, rear basket
3. Right, rear basket
4. Left, front basket
3. Mount a basket guide to the appropriate side of each
cutting unit carrier frame
Figure 2
5. Right, front basket
6. Basket guide
7. Basket bracket
(Figure
2) with a bolt (5/16 x
1/2 inch) and flat washer (0.344 x 0.875). Position the
components as shown in
1. Carrier frame
2. Basket guide
4. Install a roll pin into the lower hole in the appropriate
side of each cutting unit carrier frame
end of the roll pin should be flush with the inner side
of the carrier frame.
1. Carrier frame
2. Roll pin
3. Plastic washer
4. Basket bracket
5. On the same side of the carrier frame that the roll pin
is installed, mount a plastic washer, basket bracket,
torsion spring, basket collar, flat washer (0.344 x 0.875)
and bolt (5/16 x 1-1/4 inches)
Note: The plastic washer, basket bracket, and torsion
spring fit onto the basket collar.
The gold torsion spring is for the left-hand side of the
carrier frame and the black spring is for the right-hand
side of the carrier frame. The longer leg of the spring is
to be positioned around the front of the carrier frame
3
Figure
3.
Figure 3
3. Flat washer (0.344 x
0.875)
4. Bolt (5/16 x 1/2 inch)
(Figure
Figure 4
5. Torsion spring (left hand
shown)
6. Basket collar
7. Flat washer (0.344 x
0.875)
8. Bolt (5/16 x 1–1/4 inch)
(Figure
4).
4). The
Advertisement
