Table of Contents
Advertisement
2
1
Figure 38
1. Battery clips
2. Battery cover
2. Connect a 3 to 4 amp battery charger to the battery
posts (Figure 39). Charge the battery at a rate of 3 to 4
amperes for 4 to 8 hours.
Figure 39
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
3. When the battery is charged, disconnect the charger
from the electrical outlet and the battery posts.
4. Install the battery cover and secure it with the clips.
Remote Control Battery
Installation/Change
Remote control units are powered by three size AAA batteries.
When installing batteries, be sure to observe proper polarity as
marked on the inside of the compartment to avoid damaging
the unit. To replace or install batteries in the remote control:
3
G02071 1
3. Battery box
1. Remove the four small Phillips screws from the Battery
Compartment cover and lift the cover from the remote
control.
2. If installing batteries in an empty battery compartment,
install three fresh size AAA batteries. Be sure to
position the batteries as shown in Figure 40.
3. If replacing expired batteries, remove the old batteries
and install three fresh size AAA batteries. Be sure to
position the batteries as shown in Figure 40.
4. Replace the compartment cover and tighten the
four Phillips screws. These screws should not be
over-tightened, but they should be tight enough to
assure the gasket provides a proper seal.
Note: Be sure to observe proper polarity when placing
batteries in the remote control battery compartment.
1
1. Cover screw
Fuse
A 15 amp in-line fuse is incorporated into the machines
wiring (Figure 41).
1. Fuse
28
2
g017703
Figure 40
2. Sealing gasket
Figure 41
Advertisement
Table of Contents
