Page 1
Macurco Aerosol CO Field Test Gas CME1-FTG ™ User Instructions IMPORTANT: Keep these User Instructions for reference.
Page 2
Macurco CM-E1 and CM-6 CO detectors. This field test gas allows installers to do a quick functionality test of the CO sensor. The flow rate of the CME1-FTG is 10 Lpm so you will have about a minute of gas or enough to test 20-30 sensors.
Page 3
Testing the Fan Relay Note: The time to activate the Fan relay depends on the delay setting. 1. With the display function turned “On”, the CM-6 will show the current concentration of CO or “0” (zero) in clean air. 2. With the cover in place, direct the gas into the housing by placing the nozzle of the aerosol can onto the sensor grate area (under DO NOT PAINT) and press for 2 to 3 seconds.
Page 4
MACURCO FIXED GAS DETECTION PRODUCTS LIMITED WARRANTY Macurco™, warrants the CME1-FTG field test gas will be free from defective materials and workmanship for a period of two (1) years from date of manufacture (indicated on the gas bottle label), provided it is maintained and used in accordance with Macurco instructions and/or recommendations.