Operation - DeWalt DCF620 Instruction Manual

i_WARNING:
To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
IMPORTANT: When attaching or replacing the belt hook (K) , use
only the screw that is provided. Be sure to securely tighten the screw.
The belt hook (K) can be be attached to either side of the tool using
only the screw provided, to accommodate left- or right- handed
users. If the hook is not desired at all, it can be removed from the tool.
To move belt hook, remove the screw that holds it in place then
reassemble on the opposite side. Be sure to securely tighten the
screw.
OPERATION
_WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
FIG. 3
E,
M
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (F)into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it
does not disengage.
To remove the battery pack from the tool, press the release button (E)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual. Squeeze
the tool trigger for three seconds to dissipate the slight electric charge
that may still be in the tool. The worklight may come on for a brief
moment.
FUEL GAUGE BATTERY PACKS (FIG. 3)
Some DEWALT battery packs include a fuel gauge which consists of
three green LED lights that indicate the level of charge remaining in
the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge button (M).
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please
call 1-800-4-DEWALT (1-800-433-9258) or visit our website
www.dewalt.com.
Proper Hand Position (Fig. 4)
_ WARNING: To reduce the risk of serious personal injury. ALWAYS
use proper hand position as shown in Fig 4.
Proper hand position requires one hand on the rear grip. Take care to
not block the air vents (N).
11