How To Empty - Hoover FLOORMATE DELUXE FH40170 Series Quick Start Manual

DIrTY WaTer Tank
An automatic suction shut-off is built into the dirty
water tank to prevent the tank from overflowing.
When the shut-off activates, the cleaner will not
pick up water or debris and the sound of the motor
will change. The dirty water tank is full and must be
emptied.

How to empty

5.1 To remove tank, press down on release button
(A) and pull tank straight out.
5.2 Release tabs (B & C) on each side of the dirty
water tank to unlock the top portion of the tank.
5.3 pull up on tank lid to separate from the base.
5.4 pour dirty water into sink.
5.5 When finished emptying the tank, simply place
lid back onto the tank and make sure to latch the
tabs on each side back into the locked position.
5.6 Slide tank straight into position until latch snaps
in place.
WasHInG HarD FLOOrs
6.1 Wash Mode - Lowers the SpinScrub™ brushes
to make contact with the floor for scrubbing action.
6.2 Dry Mode - Raises the SpinScrub™ brushes
off of the floor and also stops the spinning of the
brushes.
6.3 Scrub Mode - Lowers the SpinScrub™ brushes
to the floor and stops the suction for extra cleaning
with solution and water.
6.4 To release solution, squeeze trigger (A).
6.5 Slowly move cleaner forward and backward
over area to be cleaned. Squeeze trigger to
release solution as needed.
6.6 Switch to dry mode to pick up any remaining
dirty water.
6.7 To continue cleaning another area, repeat
steps 6.4 and 6.5.
CAUTION
!
Do not clean over floor electrical outlets.
5.1
A
5.3
6.1 6.2 6.3
6.5
!
5.2
C
B
5.4
6.4
A