Advertisement
Quick Links
Please read these instructions thoroughly before beginning to install the trim kit.
Tool List: Have these on-hand before starting installation.
Phillips Screwdriver
Shims - Wooden or Plastic
Tape Measure (min. 7' length)
Safety Glasses
You should have received the following items with your collar kit option:
Item
A
Top Trim
B
Left Hand Side Trim
C
Right Hand Side Trim
D
Small Grille
E
Large Grille
F
Toe Grille
G
Center Strip
H
Corner Brackets "L" shaped
I
Set Screws (for corner brackets)
J
Hinge Covers (silver plated)
K
Phillips Head Screws - #8 x ¾"
L
Allen Head Wrench
Before you begin:
•
Be careful when unpacking components. Do not use sharp objects when removing packaging material.
This may scratch the surface of trim components.
•
Make sure that your rough opening is 66" wide by 75" tall (from top of flooring) by at least 25-1/4" deep
from the cabinet's front face. Outside dimensions of the installed kit are 66-3/4" wide by 75-1/4" high.
•
Make sure there is a large, clear area of floor (approx. 12' by 7') to assemble the trim kit. Place a drop
cloth over the floor to prevent scratching of the trim kit and/or floor.
•
Use extreme care when handling the metal trim pieces. Corners are very sharp and easily damaged if
dropped.
Always wear Safety Glasses when working with power tools and sharp objects.
DUOTRIMKIT Installation Instructions
Tape (duct or masking)
Carpenter's Level
Drill & 1/8" bit
Plastic bag contains the following:
Part #
Qnty
297032600
1
297032701
1
297032700
1
297032900
1
297032800
1
297034500
1
297034800
1
297034600
2
297034700
4
216809002
2
050149
7
1006
1
PN: 297038100
Advertisement
Summary of Contents for Frigidaire DUOTRIMKIT
- Page 1 DUOTRIMKIT Installation Instructions Please read these instructions thoroughly before beginning to install the trim kit. Tool List: Have these on-hand before starting installation. Phillips Screwdriver Tape (duct or masking) Shims - Wooden or Plastic Carpenter’s Level Tape Measure (min. 7’ length) Drill &...
- Page 2 1. Lay the parts out on a cleared area face down. See Figure 1. 2. Slide large grille (E) and small grille (D) together. See Figure 2. Make sure ends are flush then tape together to prevent parts from sliding. 3.
- Page 3 4. Attach brackets (H) to the angled end of each side trim (B and C).Gently secure brackets to side trim by tightening set screws (I), only until snug to avoid dimpling the extrusion face. See Figure 4. DO NOT OVERTIGHTEN. 5.
- Page 4 2. Making sure the frame is flush up against the front surface of Figure 7 cabinetry, carefully run one mounting screw (K) through the center hole of the top trim (A) and into the cabinetry. Do not tighten at this Back side time.
- Page 5 3. Remove the black plastic top hinge covers and Figure 10 replace with the silver hinge covers (J). 4. Remove toe grille panels at bottom of each unit. Save the four screws as they will be used later in the installation. 5.