Important Information; Information On The Display Panel; Overview Of Programmes - Siemens iQ100 Manual

Individual settings
Option buttons
The spin speed and temperature can be changed before and during the selected programme
runs. The effects depend on the programme progress.
(Spin speed / without final spin)
You can change the displayed spin speed. The maximum selectable spin speed depends on
the model and on which programme is currently selected.
temp.°C (Temperature)
You can change the displayed washing temperature. The maximum washing temperature
that can be selected depends on the programme that has been set.
(Finished in)
When you select the programme, the relevant programme duration is displayed. You can
delay the start of the programme before it begins. The "finished in" time can be set in
increments of one hour up to a maximum of 24 hours. Press the
repeatedly until the required number of hours is displayed (h = hour).
Select inicio/pausa (start/pause).
Additional function
and overview of programmes, see page 7
extra ( extra rinse) Additional rinse cycle. For areas with very soft water or for further
enhancing the washing result.
Childproof lock and reloading
You can lock the washing machine to prevent the functions you have
Childproof lock/ set from being changed inadvertently.
Appliance lock
ON/OFF: Press and hold the inicio/pausa (start/pause) button for
approx. 5 seconds after the start/end of the programme.
Note: The childproof lock can remain activated until you wish to start
the next programme, even after switching off the machine.
Then you can deactivate the childproof lock before the start of the
programme and activate it again as necessary once the programme
has started.
inicio/pausa (start/pause)
For starting or interrupting the programme.

Important information

Protecting the laundry and the machine
– When determining the dosage of all washing powders, additives and cleaning agents, you
must follow the manufacturer's instructions.
– Empty pockets.
– Look out for metal items (paperclips, etc.).
– Wash delicates in a laundry bag (tights, curtains, underwired bras).
– Fasten zips, do up any buttons.
– Brush sand out of pockets and collars.
– Remove curtain fittings or place in the laundry bag.
Laundry with varying degrees of soiling
light
(finished in) button
heavy
Soaking
Pour soaking agent/detergent into compartment II in accordance with the manufacturer's
instructions. Turn the programme selector to algodón/algodão (cottons) 30 °C and select
inicio/pausa (start/pause). After approx. 10 minutes, press inicio/pausa (start/pause) to
pause the programme. Once the required soaking time has elapsed, select inicio/pausa
(start/pause) again to continue the programme, or select a different programme.
Starching
Starching is possible in all wash programmes if liquid starch is used. Pour the starch in
accordance with the manufacturer's instructions into fabric softener compartment
if necessary).
Dyeing / Bleaching
Dye should only be used in normal household quantities. Salt may damage stainless steel.
Always follow the dye manufacturer's instructions! Do not use the washing machine for
bleaching clothes!

Information on the display panel

E3
E5
E6
E2
5
Wash new items of clothing separately.
Do not pre-wash. If required, choose the
programme.
Pre-treat any stains as necessary.
Do not load as much laundry. Select the program with prewash.
Load laundry of the same colour
Laundry must not be treated with fabric softener
Close the washing machine door properly; laundry may be caught.
Open the tap completely, supply hose kinked or trapped;
Clean the filter page 10, Water pressure too low.
Detergent solution pump blocked; Clean the detergent solution pump
Drainage hose/waste pipe blocked; Clean the drainage hose at the siphon
Motor fault. Call the after-sales service.
speedPerfect
(rinse first
depending on model
page 10.
page 10.
6