Scale Unit Installation; Maintenance Of Scale Unit - Magnescale PL25 Instruction Manual

4-3. Scale unit installation

1. Leave the scale near installation unit for about an hour so
all components will be at the same temperature when the
installtion is performed.
2. Mount the scale unit on a surface with a flatness of 0.4/
0.016"(SL130)/0.2/0.008"(SL331) mm or less.
3. Wipe the scale unit mounting surface and scale base
mounting surface with a clean, alcohol-moistened cloth to
remove, dirt, oil, etc. Attach the supplied double-sided
adhesive tape to the scale unit mounting surface and then
stick the scale to the machine.
4. Wipe the scale surface (rubber magnet) softly with clean,
alcohol-moistened cloth to remove dirt, oil, etc.
[SL130]
5. Attach the supplied double-sided adhesive tape to the
scale surface. Stick the protective ribbon to the scale
from one end while removing the lining paper.
Make sure the ribbon does not stick out from the scale
edges.
[SL331]
5. Stick the protective tape to the scale from one end
while removing the lining paper.
Make sure the tape does not stick out from the scale
edges.
Note
• Apply the stainless steel or polyester film (provided) over the
scale for protection purpose.
• When handling the protective ribbon or tape, use care not to
bend it.

4-4. Maintenance of scale unit

When DIGIRULER is exposed to dust, chips and coolant,
wipe the scale surface softly with cloth occasionally.
Do not use alcohol and detergent.
15