Page 2
Please note! The life span of electronics can be affected by damage caused by electrostatic discharge. This can happen if a charged tool or person touches a component. Therefore it is very important that all tools and personnel are discharged by touching an earthed point before the printed circuit board or any of the components are touched.
Page 3
Figure 1 This picture shows the old type of PCB. On the next page you find the new type, with the new terminals. - 3 -...
Page 4
PS – make sure that you are placing the jumper for supply voltage in the correct position , 110 – 120V or 220 – 240V DS ABB Automation Technology Products AB, Control S-721 61 Västerås, SWEDEN Telephone +46 21 32 07 00...