Fcc Interference And Compliance - Portrait Displays SpectraCal VideoForge PRO User Manual

FCC Compliance Statement
FCC WARNING
Caution
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet different from that to which the
receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
To comply with the limits for an FCC Class B computing device, always use the
shielded signal cable supplied with this unit. The Federal Communications
Commission warns that changes or modifications of the unit not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
CE mark for Class B ITE (Following European standard EN55022/1998;
EN61000-3-2/1995; EN61000-3-3/1995,EN55024/1998, EN60950-1/2001)
User Manual: SpectraCal VideoForge PRO
17