Preparing The Parts And Tools; Mounting Procedures - Sony Magnescale SR118 Series Instruction Manual

3-2-4. Preparing the parts and tools

The following parts should be prepared when mounting the
scale unit.
Supplied parts
• Screw 1 +PS2 × 4
• Screw 2 +PS2 × 8
• Screw 3 +P3 × 16
• Screw 4 HSB4 × 16
• Screw 5 +B4 × 8
• Blindfold label
• Wiring clamp (small)
• Wiring clamp (large)
Items to be provided by the customer
• Phillips screwdriver No. 2
• Drill rod
• Drill rod
• Tap
• Drill press or electric drill
• Liner spacer
• "L" wrench
2
2
2
2
4
1
2
2
ø1.6 (for M2 prepared holes)
ø3.4 (for M4 prepared holes)
For M2 and M4
t 0.05 to 0.2 mm
(t 0.002 to 0.008 in)
Opposite side 3 mm (0.118 in)
(for M4)

3-3. Mounting Procedures

Note
• This section describes the procedures for mounting the
scale unit.
• Absolutely do not disassemble the following parts while
mounting the scale unit as this may result in malfunction.
(Locations where disassembly is prohibited)
• Slider components and electrical parts
• Connectors
• Scale unit (scale and brackets)
• The scale unit is comprised of precision instruments, so
applying excessive force will adversely affect the unit's
precision and service life. Care should be taken not to
apply excessive force to the scale unit while mounting the
unit.
• Be sure to support the scale unit and slider when carrying
the scale unit. Do not carry the scale unit by the cables or
connectors, etc.
27