Installation - Titan TTS-S05-5.5 Manual

INSTALLATION

Please install the batteries and tube first before
using, and choose the
accessory according to actual application.
Steps of installation as below:
Step 1: To install batteries
1. Using a screwdriver and remove the screws and
open the battery cover.
2. Insert four new AA batteries in the battery
compartment directly.
Proper battery orientation is indicated on the battery
compartment
3. Close the battery cover and screw as before.
NOTE: Dry your hands before installation or
replacing batteries.
Step 2: To install the camera with flexible
tube
Connect the camera with flexible tub to the body and
make sure the
keyed ends are properly aligned. Once they are
aligned, tighten the
knurled knob to hold the connection in place.
Step 3: To install accessory
The three included accessories: Mirror, Hook and
Magnet, all attached
to the camera by the same way. To install as below:
Use the green lantern ring
to hitch the tube
Put accessories into the hole
Slide the green lantern ring to lock the accessories
Make sure put each accessory into the hole of the
stem of camera part,
and slide the green clip to lock each accessory
Step 4: To install monitor for wired use
The product also supports wired by connecting the
monitor to the body with camera.
Step 5: To connect monitor's power
Plug the connect cable into the power socket of
monitor, and plug the end of connect cable to
adapter, then connect the adapter to 6V power, the
power indicator will lights as red, which indicates
being charging.