Operating - Medisana MTR Instruction Manual

3.7
If you want to hear Radio, press the Radio
Radio function
mode indicator: Radio
and time
you can start a scan for available radio stations. The volume can be
adjusted with set volume button
simply press the START button

4 Operating

4.1
1. Open the storage case
Fitting the cuff
1 - 2 cm
b
a 2. Slide the open end of the cuff through the metal bracket so that the
3. Open the cuff so as to create a cylindrical shape.
4. Slide the cuff over your left upper arm. Position the air hose in the
c
5. Place your arm on the table with the palm uppermost. The lower
6. Avoid creating a space between arm and cuff. It may falsify the
7. Measure the pulse on your bare arm. If wearing tight clothing,
8. Only position the cuff on the right arm if it cannot be used on the left
4.2 The Correct Measuring Position when sitting
Correct position • Carry out the measurement whilst seated.
for taking • Relax your arm and place it comfortably, on a table for instance.
readings • Ensure that the cuff is at heart height.
• Keep still during the measurement: do not move and do not talk as
⁄
will be displayed. With the buttons "+/A"
]
pressing the latch for storage case
. Push the end piece of the
@
air tube into the hole on the unit
prior to use. Ensure that the hose
is not damaged and is securely
attached. The blood pressure
monitor is intended for use as a
table-top unit.
Velcro fastener is on the outside.
middle of your arm in line with your middle finger (a).
edge of the cuff should be 1 - 2cm above the crease of the elbow (b).
Pull the cuff tight (c) and close the Velcro fastener.
measured result.
ensure that the circulation in the arm is not impaired when rolling
up the sleeve.
arm. Always carry out measurements on the same arm.
this may alter the measurements.
3 Getting started / 4 Operating
;
will light up and the frequency
To deactivate the radio function,
+
.
(
by
/
button. The operation
, date
I [
resp. "-/B"
% &
23
GB