Advertisement
7.2 Over-speed Alarm setting（It works only in continuous positioning mode.）
Over-speed Alarm setting:
：speed123456
Command
60KM/H
Reply：speed ok
E.g：
When the unit speed is over 70km/h, it will send message "speed alarm!" to the
admin number .
Over-speed Alarm canceling ：
：nospeed123456
Command
Reply：nospeed ok
7.3. move Alarm setting (It works only in getting gps signal, the scope is a
circle that radius 200meters)
Command：move123456
Message
Reply：move ok
E.g：
move alarm Canceling:
Command：nomove123456
Reply：nomove ok
7.4 Terminal (local) Time Setting(factory setting GMT 0)
Command：time zone123456 local time zone
Reply：time ok!
E.g：
time zone123456 1
time zone123456 5 30
70（Suppose speed is 70km/h）note: not less
time zone123456 -1
Time zone123456 0
Advertisement
