Advertisement
Step 7: Installing the Main Cover
a.
To make sure the strap will stay in the sleeve when assembly
thread the strap through the spindle of the ratchet.
Raise and lower the handle two or three times to wind the
strap onto the spindle (as shown in
b． Lay the cover on the ground next to the frame with inside of
the cover (the side with pipe pockets)facing upword and the
webbing on the front and rear of the corner of the building．
c．
Tie one end of a rope to the eyelets on one corner of the
cover, then another rope to the other corner eyelets．
Pull cover over the frame by the help of the rope as Diagram
d．
L, making sure to center cover on frame.There should be an
equal amount of overhanging at all four corners.
e.
Insert the
''S''-
hook on ratchet into hole on the Bent Corner
Leg. Wind the ratchet so that the webbing overlaps itself.
f.
Disassemble cover rails and slide through fabric pockets at
each leg and reattach with clamps to each leg. Repeat this
on the other side. Push down on cover rails to tighten cover,
before tightening bolts completely.
g.
When the cover rails are all secured, then proceed to the
4-corners and tighten the end covers to the end frames
through the ratchet action.
NOTE： Over-tightening can cause damage to straps
and/or the anchor point.
DO NOT over-tighten!
The shelter is now ready for use.
Note
Please check periodically (two to three times
i n the first week-weekly for the balance of the first
month of set up) and tighten ratchet tie-downs and
all hardware as needed. Monthly inspection is
recommended throughout usage．
Disassembly:
When disassembling the shelter, depress the spring-
loaded bar and open ratchet handle completely to
allow the webbed belt to disengage the ratchet．
PLEASE RE-READ ALL WARNINGS CONTAINED
ON PAGE 2 OF THIS INSTRUCTIONS. SAVE
THESE INSTRUCTIONS FOR FUTURE USE.
To dismantle, execute all instructions in reverse order.
Store your shelter in a cool, dry location between
seasons to prolong usable life of all components.
Components are not equally durable and will require
replacement over time at differing intervals.
Diagram L).
Diagram L
L1
Rope
8
L2
Rope
Roof Tarp
22
13
23
24
22
14
23
24
Spring-loaded bar
Advertisement
