Advertisement
Step 6: Installing the Front and Back Covers.
The front cover contains a zippered door to allow entry and exit to
the shelter. Ensure to locate this cover to the desired end. Also,
ensure the zipper is in the 'closed' position while installing. The back
cover is a solid piece of polyethylene. The covers are installed
in the same fashion.
a.
To make sure the strap will stay in the sleeve when assembly
thread the strap through the spindle of the ratchet, and
make sure the strap will stay in the clasp.
b.
Begin with the front cover and first locate the webbed
belt that runs the perimeter of the cover.
c.
The webbing is exposed at the peak, the shoulders and
the feet of the cover. And there are 3 buckles at the above
3 positions.
d.
Unlock the buckle, slip the webbed belt around the
side 3-way connector and relock the buckle again.
e.
Repeat this step for the opposite shoulder.
Move to the peak of the shelter using a step stool or
f.
ladder if necessary. Unlock the buckle around the peak
3-way connector and relock the buckle again.
g.
While one person remains on the stool and standing
at the peak of the shelter, the other person inserts the
S-hook of the clasp into both sides of corner legs (K3).
h.
The person standing at the peak assists by ensuring
the tarp is partially foIded over the pipes of the end
frame and inside or toward the interior of the shelter.
i.
The other person make sure the door panel flat and then
pulls the strap tightens.
j.
Repeat above steps for the other side of the Back
Panel assembling.
DO NOT OVERTIGHTEN RATCHETS AT THIS TIME!
Diagram J
Diagram K
9
4
9
K1
Door panel inside view
K3
DETAIL K2
7
DETAIL K1
K2
DETAIL K3
8
Advertisement
