Advertisement
NAV VIDEO NavVideo Installation Guide. © 2006.
13
Step 4: Unplug 3 OEM Connectors Behind LCD Display, And Install GM Unlock Module In Line
Step 5: Connect Video Devices
Connect any video and audio devices to the inputs of the module before reassembling the dash.
Step 6: Aftermarket Bluetooth Kit Connection
If you have an aftermarket Bluetooth kit to add to the module, install it at this time and follow the instructions
included with the kit.
Step 7: OPTIONAL – For OEM REAR CAM CONTROL
If you would like to enable full control and viewing of your FACTORY REAR VIEW CAMERA
when in DRIVE, attach the included FACTORY CAMERA OPTION wire to the REVERSE wire
labeled in your GMUNLOCKPRO harness. A crimp connector is already attached for your convenience.
Route the wire along the edge of the console and down to the small silver module under the passenger
seat. Slide the seat all the way back to view the connector on the front or side edge. Unplug the
connector and cut the Blue wire pictured in the photo below ( end wire, left side, from the back of the
plug ). Crimp the Blue wire from your kit to the blue wire on the connector. The other cut end of the
wire in the factory harness should be insulated and left disconnected. Do not connect the GMUNLOCKPRO
Blue wire without cutting the factory wire or improper operation will occur. For 2008 H2 Hummer
installations, run the GMUNLOCKPRO blue wire to the back of the vehicle and connect directly to the rear
view camera connector blue wire. Other vehicles (Enclave, Acadia) may place the module in the rear as well
Advertisement
