Page 1
IMPORTANT NOTE: Technical support on this product is only available via e-mail. Before submitting a technical support e-mail please thoroughly read through this installation guide and double check your installation. If you have a technical question please send an e-mail to support@navvideo.com.
Page 2
NAV VIDEO navigation interface from you, in or out of your vehicle. NAV VIDEO cannot be held responsible for discrepancies, or inconsistencies that may occur due to vehicle manufacturing changes.
Page 3
– Press the MUTE button two (2) times within 3 seconds. When activating the GMUNLOCKPRO for navigation override only, the unit is designed to automatically “time out” after approximately 60 seconds. If you need additional time after this period, simply press the mute button two (2) times again for an additional 60 seconds.
Page 4
7 of the installation guide. The ignition key must be fully ON to enable the camera or extra video inputs on the GMUNLOCKPRO. 4. To turn on the video inputs of the GMUNLOCKPRO and view your attached accessory, place the radio in XM mode. Now, press the WINDOW LOCKOUT button four (4) times within 4 seconds.
Page 9
Video & Audio Inputs An important feature of your GMUNLOCKPRO is the ability to easily input video from a backup camera and two additional audio and video sources (rear, front, baby cam, DVD, video iPOD, ZUNE, etc. or as a video...
Page 11
**Note (switch 2 UP) - When using the GMUNLOCKPRO for DVD/AUX/NAV override and for control of multiple cameras, the video inputs on the GMUNLOCKPRO module will be used for camera inputs and are not available for other video sources. Also, if your vehicle already has a factory rear view camera...
Page 13
Blue wire without cutting the factory wire or improper operation will occur. For 2008 H2 Hummer installations, run the GMUNLOCKPRO blue wire to the back of the vehicle and connect directly to the rear view camera connector blue wire. Other vehicles (Enclave, Acadia) may place the module in the rear as well...
Page 14
Your GMUNLOCKPRO can also automatically control a front, rear and 2 side cameras!! If switch 4 is placed in the up position, the GMUNLOCKPRO will automatically turn on a front camera while at speeds less than 8 mph. If switch 2 is placed up, the side cameras will activate when the corresponding turn signal is switched on.
Page 15
Source 2 video as described above, and follow the Bluetooth kit instructions. Your GMUNLOCKPRO requires a only couple of seconds when the car is first turned on before it can access the video functions so allow a brief moment before you turn on the video source.
Page 16
The section below is only for GM / Cadillac service technicians. This feature is not supported officially by NAV VIDEO and is entirely at the discretion of the GM / Cadillac technician and associated dealership. This is an OPTIONAL step and only needs to be done if you wish to use the video input feature of our module to add an aftermarket backup video camera or other video device.