Table of Contents
Advertisement
Quick Links
Installation & Operation Manual
The CO
sensor AVG TFT is carefully designed and tested to monitor levels of carbon dioxide (CO
2
air and used in areas where CO
referenced for typical installation and operation only.
For site specific requirements that may deviate from the information in this guide – contact your supplier.
Rev: 08 07-20
CO
Sensor AVG TFT
2
Carbon Dioxide Gas Monitor
Installation & Operation Manual
Please read this manual carefully and retain for future use.
could be a concern. The information contained within should be
2
Merlin CO2 Monitor AVG TFT
2
) in the
1
Advertisement
Table of Contents
Related Manuals for S&S Northern Merlin CO2 AVG
Summary of Contents for S&S Northern Merlin CO2 AVG
- Page 1 Installation & Operation Manual Merlin CO2 Monitor AVG TFT Sensor AVG TFT Carbon Dioxide Gas Monitor Installation & Operation Manual Please read this manual carefully and retain for future use. The CO sensor AVG TFT is carefully designed and tested to monitor levels of carbon dioxide (CO ) in the air and used in areas where CO could be a concern.
-
Page 2: Table Of Contents
Installation & Operation Manual Merlin CO2 Monitor AVG TFT Content INSTALLATION ..................3 Planning ......................... 3 Typical Positioning ....................... 3 Wiring ..........................4 Specification ........................ 4 OPERATION ....................5 First Power Up ....................... 5 Screen Explanation ..................... 5 Screen Brightness ......................5 End of Life ........................ -
Page 3: Installation
Installation & Operation Manual Merlin CO2 Monitor AVG TFT INSTALLATION Planning Your new CO sensor is carefully designed and tested to monitor levels of carbon dioxide (CO in the air and used in areas where CO could be a concern. The device will measure and display the CO value in ppm (parts-per-million) with digital display indications. -
Page 4: Wiring
Installation & Operation Manual Merlin CO2 Monitor AVG TFT This device is designed for surface mounting using 2 mounting screws (not supplied) and MUST be installed by a competent person. Mark the location of the two holes needed on the wall using the back plate as a template. Removing the back plate gives access to the circuit board. -
Page 5: Operation
Installation & Operation Manual Merlin CO2 Monitor AVG TFT OPERATION First Power Up Turn your device on. Supply 240VAC mains to the [L N POWER] terminal. After initial warm up (60 seconds) the screen will show CO level in the area. Turn your device off. -
Page 6: End Of Life
Installation & Operation Manual Merlin CO2 Monitor AVG TFT End of Life This indicates that the device requires immediate replacement. The gas monitoring elements are expected to last for 10 years from initial installation and power up depending on environmental factors. Contact your supplier. -
Page 7: Important Warning Statements
Installation & Operation Manual Merlin CO2 Monitor AVG TFT IMPORTANT WARNING STATEMENTS Please take the time to thoroughly read this user’s guide which should be retained for future reference. The expected lifetime of the gas sensor elements is 10 years upon initial power up. The device will display a message to indicate its end of life and should immediately be replaced. - Page 8 Installation & Operation Manual Merlin CO2 Monitor AVG TFT S&S Northern - Head Office Tel: +44(0) 1257 470 983 Fax: +44(0) 1257 471 937 www.snsnorthern.com info@snsnorthern.com South East Division Tel: +44(0) 1702 291 725 Fax: +44(0) 1702 299 148 south@snsnorthern.com S&S Northern is the owner of this document and reserves all rights of modification without prior notice.