Auto Power On/Off; Initial Settings - HP f530g Quick Start Manual

Table of Contents

Advertisement

2.4 Auto Power On/Off

Once the vehicle engine is started, the camcorder automatically turns on.
If the Automatic Record function is enabled, the recording will
automatically start right after the camcorder turns on.

2.5 Initial Settings

Before using the camcorder, we recommend you to enable the
Automatic Record function and set up the correct date and time.
2.5.1 Setting the Universal Time Code (UTC)
Depending on your location, you may need to change the current UTC
setting of the camcorder so that the correct date and time are updated
when a GPS signal is detected.
* Be sure to adjust for daylight saving time (DST) by adding +1 hour to the UTC
offset
** These areas may observe half hour increments and daylight saving time (DST)
8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the f530g and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents