Table of Contents
Advertisement
INSTALLATION - Power
1.
It is recommended to have at least 5A avaialble to power the screen. The input is 11-16Vdc.
2.
It is recommended to wire the screen to ignition or a timer to prevent the battery from draining.
3.
Make sure power is off before performing any install steps.
4.
Bare wire power cable installation:
Attach the red cable to the positive power source.
Attach the black cable to the ground.
If turning on power to the system, the mounting surface (metal) may be hot to the touch.
WARNING: Hot Surface, Do Not Touch
INSTALLATION - Mounting
1.
It is required to secure and zip-tie the ports listed on page 4, to guarantee performance.
2.
If mounting to a Gamber-Johnson clevis, use the Hanging Bracket to place the screen and
support the weight while attaching the Mounting Bolts included with screen.
3.
If mounting to other equipment, remove and toss the Hanging Bracket and screws.
INSTALLING THE TOUCH SCREEN
Mounting Bolts and washers (x4)
Hanging Bracket
IEC 60417-5041(DB 2002-10)
BLACK WIRE
- to ground
RED WIRE
- to power
5 / 9
Advertisement
Table of Contents
