Table of Contents
Advertisement
PRE-INSTALLATION RECOMMENDATIONS
Gamber-Johnson (GJ) recommends the positioning of all mounts and equipment in the
vehicle prior to the actual install to verify mounting locations are safe and practical.
Gamber-Johnson strongly advises a "bench test" be conducted to verify all electronic and
software issues are resolved prior to installation. Follow these steps:
1.
Make sure the computer functions by itself as intended.
2.
Connect the touch screen and make sure it functions with the device.
3.
Connect other equipment and verify start-up of all components and specific
software (mouse, flashdrives, printers, etc.).
IMPORTANT SAFETY INFORMATION FOR INSTALLERS
Before Installation
Safety is dependent on the proper installation and servicing of this touch screen. It is important
to read and follow all instructions before installing this product. Use proper mounting equipment
or hardware to secure this touch screen.
Safety is a top priority for Gamber-Johnson. To properly install Gamber-Johnson equipment, you
must have a good understanding of automotive electrical procedures and systems, along with
proficiency in the installation and service of aftermarket vehicle equipment.
WARNING: Opening the touch screen will void the product warranty. There is no need to adjust
the electrical components within the touch screen at any time.
During Installation
Do not install equipment or route wires or cords in the deployment path of any airbag.
When drilling into the vehicle, ensure both sides of the surface are clear of anything that
could be damaged.
See the bare wire installation instructions on page 5 for safe and correct installation.
WARNING: If wiring is shorted to the frame, high current conductors can cause hazardous
sparks resulting in electrical fires or flying molten metal.
After Installation
Test the touch screen to ensure it is working properly.
1.
Do not use the screen if the power cable or plug is damaged.
2.
Do not use the screen if water contacts the rear of the screen, the ports, or the
speakers. Immediately disconnect power and ensure the system is dried.
File these instructions in a safe place and refer to them when performing maintenance or re-
installing.
WARNING: Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death.
2 / 9
Advertisement
Table of Contents
