Reely Vector 48 Operating Instructions Manual page 40

To do this, move the steering wheel on the remote control to the neutral (central) position, and then set the trim to the
neutral position. Use a suitable hex key to loosen the pushrod connection on the rudder system's steering linkage.
Adjust the steering linkage until the rudder is straight, and then tighten the screw on the pushrod connection.
Metal screw connections must be secured with lock nuts or a drop of thread-locking fluid to prevent them
from becoming loose.
Move the steering wheel to the left (anticlockwise, see figure 4). The rear edge of the rudder (viewed from behind)
should move to the left.
Move the steering wheel to the right (clockwise, see figure 4). The rear edge of the rudder (viewed from behind) should
move to the right.
Check the forward throttle. Move the throttle on the remote control (see figure 5) to adjust the speed of the ship.
The more you pull the trigger towards the handle, the faster the propeller will spin and the faster the boat will move.
The propeller rotates in an anticlockwise direction (when viewed from behind). The motor is off when the lever is the
central position.
Reversing is possible by pushing the throttle on the remote control away from the handle.
40
Figure 4
Figure 5