Table of Contents
Advertisement
damaged in transit, notify the shipper immediately and keep the packing material
for inspection. Again, please save the carton and all packing materials. If
a fixture must be returned to manufacturer, it is important that the fixture
be returned in the original manufacturer box and packing.
Safety Instruction
For your safe, please read this user manual carefully before turn on
the fixture. This machine should be operated by qualified engineer！
Please conserve this manual as operation guidance. If you sell this product to
other user, please make sure that they also receive this user manual.
Always make sure that you are connecting to the proper voltage and that the
line voltage you are connecting to is not higher than that stated on the decal or
rear panel of the fixture.
If the fixture is intended to indoor use only. To prevent risk of fire or shock, do
not expose fixture to rain or moisture. Make sure there are no flammable,
explosive or corrosive materials surrounded in 10meters while operating.
The unit must be installed in a location with adequate ventilation, at least 5m
away from adjacent surfaces. Be sure that no ventilation slots are blocked.
Some fixture may carry high heat, do not aim at objective more than 2minutes.
Safe rope should be used to install machine. Bearing of safe rope should be
more than 3times of the machine weight. Complimentary signal cable transmits
signals to 20 unit fixtures at most. Signal amplifier is a must to connect more
fixtures. And a terminal should be added at the end of last fixtures' DMX
sockets, 120 Ohm, 1/4W resistance need welding between Pin 2 and Pin3.
Always disconnect from the power source before servicing or replacing
fuse/lamp and be sure to replace with same fuse/lamp size and type. Cut off
power before moving, repairing and cleaning the machine.
To avoid electric shock, all fixtures must be connected to circuits with a suitable
earth connection.
Always secure fixture using a safety chain and carrying handles.
Do not operate at ambient temperatures higher than 104℉(40℃).
Advertisement
Table of Contents
