Advertisement

Quick Links

Precaution and Notice
The PND is used only as a navigation aid. It is not for precise measurement of direction, distance, location
or topography. The user must follow all traffic signs and local regulations along the roads.
GPS satellite signals cannot pass through solid materials (except glass). When you are inside a tunnel or
building, GPS position is not available.
A minimum of 4 GPS satellite signals are needed to determine current location. Signal reception can be
affected by situations such as bad weather or dense overhead obstacles (e.g. tall buildings).
Other wireless devices in the vehicle might interfere with the reception of satellite signals and cause the
reception to be unstable.
When you get out of the car, do not leave your PND on the dashboard or subject to direct sunlight. The
overheating of the battery may cause malfunctions and/or dangerous conditions.
For your own safety, do not operate the controls of the PND while driving. Do not mount where the driver's
field of vision is blocked.
Battery rupture or explosion will release dangerous chemical substance. So in order to avoid fire or be
burned, please do not disassemble , pierce, knock or throw the battery to fire or water.
Intense humidity fluctuations or moisture will contribute to machine internal short-circuit. Therefore, it is
better to start up the device after the device adapting the surrounding when the external condition changes
WayteQ GPS MID
n800
User Manual
Version 1.1

Advertisement

Table of Contents
loading

Summary of Contents for WayteQ GPS MID n800

  • Page 1 WayteQ GPS MID n800 User Manual Version 1.1 Precaution and Notice The PND is used only as a navigation aid. It is not for precise measurement of direction, distance, location  or topography. The user must follow all traffic signs and local regulations along the roads.
  • Page 2: Basic Introduction

    Please copy system data to external storage devices when update system data. WayteQ Technologies is not  responsible for system data corruption or loss. GPS Maintenace Please use stylus to tap and operate the navigator, never press the touch screen forcefully. Please use soft ...
  • Page 3: Power Supply

    A. Indicat on Light B. Power C. SD Card slot D. Mini USB E. Speaker F. MIC hole G. Reset H. Earphone Jack Once the card is installed, it cannot be removed during the operation of the device. If you need to remove the card, switch the unit off first, push the card in and it will eject from the slot. 1.2 Power Supply N800 navigator uses built-in, irreplaceable Li-Polymer battery as power supply , battery icon “...
  • Page 4: Main Functions Introduction

    Please charge the device for more than 1 hour by AC adapter when you use the device for the first time. Please charge the device in time when low battery or battery depletion. Please keep the device in a cool and dry place with more than half of battery capacity when not use the device for a long time.
  • Page 5: Reset System

    . Tap the icon on the top-left corner, then you can enter into the related info service and quick setting. WayteQ LOGO, tap and enter into system info interface Battery Status display...
  • Page 6 Tapping “turn on”: turn on Wi-Fi module Tapping “turn off”: turn off Wi-Fi module Choose and tap the available network, then tap “advance” icon, you can set the network as below interface : Tap “IP setting” icon, you can set the network address (interface as below). Select Auto or Manual for network setting.
  • Page 7 Tap “ “ to choose hiding or showing the soft keypad , you can input web address by the keypad . Tap” “ to return to home page . Tap” “ to enter into favorite list interface as below : Tap”...
  • Page 8 Tap” “ to view history website . Tap” “ to enter into Setting interface : You can set “ Home Page “ , “ Text Size “ and “ Encoding “ . Tap “ Memory “ , you can clear web view history . Tap”...
  • Page 9 Tap the “ Device list ” icon and enter into the following interface : Tap the “ ” icon to connect the chosen device , tap the “ “ to disconnect , tap the “ “ to delete pair info . If paired mobile phone not in the device list, please tap the “...
  • Page 10 If incoming call , the interface as below . Active the call , and interface as below :...
  • Page 11 Tap the “ “ icon and enter into Bluetooth setting interface as below. Name : display name of the device in the process of the Bluetooth transmission . Pin: Tap the icon “ “ and enter into pin code interface . Optional Bluetooth Value Added Functions Dial-Up Network ( DUN ) Notice: The paired mobile phone must support GPRS function.
  • Page 12 Double tap “Dialup Networking Service” and enter into GPRS setting interface as below: You can choose GSM/GPRS network operator or input network operator name, then tap “connect”. Return to the main menu after connection successfully , and tap the “IExplorer” icon to surf the internet. Phonebook Tap the “...
  • Page 13 Select phone number , and tap “ “ to dial the number . tap the “ “ to delete the selected number . 6. Music Tap the icon “Music” on the main menu and enter into the following interface . A.
  • Page 14 Tap the icon “ “ for single selection , tap the icon “ “ to select all , tap the icon “ “ single delete , tap the icon “ to delete all . ” 7. Photo Tap the "Photo" icon on the media menu and tap the icon “ “...
  • Page 15 8.1 Ebook Tap the "EBook" icon , then tap the " " icon to choose Ebook files , double tap the file and enter into the following interface . A. Return to the Media menu B. Bookmark list C. Bookmark D.
  • Page 16 A. Volume B. Return to the Media menu C. Select flash file D. Stop E. Play / Pause F. Speed Bar 8.3 GsFinder Tap the icon “ GsFinder ” and enter into the following interface , to manage, view or find files . 9.
  • Page 17 A. Return to the Media menu B. Volume C. Select video file D. Stop E. Next F. Pause/play G. Previous H. Speed bar Tips: Tap NEXT button to recycle the movie. Double tap the screen, it will display in full screen, double tap the screen again, it will return to original playing size. 10.
  • Page 18 11. Games Tap the icon "Games" on the main menu and double tap the game to run it . 12. Setting Tap the icon "Setting" on the main menu and enter into the following interface .
  • Page 19 Tips : after make any changes of setting , tap " " to save the change . 12.1 Volume Tap the icon “Music” on the media menu and enter into the following interface . Choose “ Music “ files to be background sound when unit is power on . 12.2 Backlight Tap the "Backlight"...
  • Page 20: Date And Time

    12.4 Date and Time Tap the icon "Date Time" and enter into the following interface to set date , time and time zone . 12.5 Calibration Tap the " Calibration " icon and enter into the following interface . Tap the icon "OK" to adjust the touch screen. 12.6 Factory Reset Tap the "...
  • Page 21: System Info

    12.7 System Info Tap the "Sys Info" icon and enter into the following display interface . 12.8 USB Tap the icon “USB” to set the USB working mode . 12.9 Nav Path Tap the "Nav Path" icon and enter into the following display interface .
  • Page 22 When you have several Navigation maps in the device, if you choose the "Navigation" icon , you can set up one of Navigation maps ( navigation program files ) , and select the Auto Run Navigation , next time when tapping the “GPS”...
  • Page 23 Internet Explorer to visit website Use Windows Messenger to contact with your friends Enter into WiFi interface Manage files in your device Read PDF files View pictures file Read Windows Word files Read Windows Excel files Read Windows PowerPoint files Notepad Windows Media Player This document is for guidance only and does not form part of any contract, and may be subject to...

Table of Contents